Adding a warp drive to my SVs isn't working as well as I had hoped. Some it worked just fine... others I am not so certain. The following two blueprints are very much related, but I only want to keep one. I am just having trouble choosing which to keep. If it was just a matter of which was cheaper, or which was tougher, then it would be easy. One is clearly cheaper than the other, and the other is tougher. But I have cheaper blueprints than both these. Acceleration, they are very similar. Both only use starting materials with cavities for adding in a warp drive. Any input on choosing which to keep and complete would be appreciated. The above is a slightly larger variant I had created to be tougher than the original. I had pulled this from the Steam workshop in preparation for a complete redesign to make it look less like the original. But when at first I didn't like how adding a cavity for the warp drive turned out with the original, I thought perhaps this bigger variant might look better with a cavity for the warp drive.... The above is the original with cavity for warp drive added. The original is cheaper. The variant is tougher. Both accelerate about the same, but I want to keep only one. The other will be "retired" to make room for a whole new variant in my blueprints. Which is I only want to keep one so I can make something else newer. So any counsel on which one is the better choice to finish painting and keep would be appreciated.
